Omega Driver for DasyLab software

[Thomas Bell Wright]

We are currently attempting to install the Omega Driver on the DasyLab software but have encountered some difficulties.

Could you please provide guidance or detailed instructions on how to properly install the Omega Driver?

If there are any specific requirements or steps that I should be aware of, please let me know. Your assistance in resolving this matter would be greatly appreciated.

[Fausto]

Hello @Thomas Bell Wright.

Which DASYLab version and option are you using?

Which Omega device are you using?

Launch DASYLab's Configurator to enable the Omega package before using the device in DASYLab.

 

If your device is a rebranded Measurement Computing device, then you may be able to use the 'Measurement Computing' package.  Note the requirements in the description for each package.

Afterward, close the Configurator and launch DASYLab to access the modules.  The available modules depends on which package was enabled in the Configurator.  The following image shows the MCC modules.  

 

Regards,

Fausto