I have an AD2 connected to a BNC adapter connected to a amplifier, connected to a transducer, then on the other side I have a receiving transducer which is connected back to channel 1 of the the BNC adapter.
The waves get generated using waveform software and receiving if is also done on the software. My first problem is getting the delay time between transmission and the receiving transducer so I can calculate the thickness of the part. The only thing I can get is the change in amplitude. I wanted to ask if its possible to get time delay with this setup especially since I can not overlay the wavegen graph to the scope graph?
Also with this setup I would like to have a pulse echo setup of which I am also not sure if its possible, please advice.
Question
Zamokuhle
Hi,
I have an AD2 connected to a BNC adapter connected to a amplifier, connected to a transducer, then on the other side I have a receiving transducer which is connected back to channel 1 of the the BNC adapter.
The waves get generated using waveform software and receiving if is also done on the software. My first problem is getting the delay time between transmission and the receiving transducer so I can calculate the thickness of the part. The only thing I can get is the change in amplitude. I wanted to ask if its possible to get time delay with this setup especially since I can not overlay the wavegen graph to the scope graph?
Also with this setup I would like to have a pulse echo setup of which I am also not sure if its possible, please advice.
Regards
Zamokuhle
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now