Introduction

[floordoc]

My name is Paul Elliott. My company is working on developing a new data acquisition module using DAQHATS and matlab. I'm not finding much info on either site. Hoping to use this forum to help with the process. 

[DAQman]

Here is the resource page for the MCC DAQHAT boards: https://mccdaq.github.io/daqhats/overview.html

The following are the DAQHAT electrical specifications. Under the Interface Specification section, you will find a listing of the GPIOs used by each board.

https://mccdaq.github.io/daqhats/_static/esmcc152.pdf

https://mccdaq.github.io/daqhats/_static/esmcc118.pdf

https://mccdaq.github.io/daqhats/_static/esmcc128.pdf

https://mccdaq.github.io/daqhats/_static/esmcc172.pdf

 

Here is Mathwork's resource page for their Raspberry Pi support: https://www.mathworks.com/help/matlab/raspberrypiio.html

 

[floordoc]

DAQman, Thank you very much. I have read those daqhat sheets on github several times. I was not convinced it was there. Upon review, I found that I needed. 

For anyone reading later - Here is what I saw. I only put the boards I was using here. Found in Interface Specifications.  It might save you some time.

MCC172 - & MCC128 (both were identical). 

• GPIO 8, 9, 10, 11 (SPI interface)
• ID_SD, ID_SC (ID EEPROM)
• GPIO 12, 13, 26 (Board address)
• GPIO 16, 20 (Reset, IRQ)