Jump to content
  • 0

Terminal assignment and application display


Roman Slizynski

Question

5 answers to this question

Recommended Posts

  • 0

In manual page 10 figure 2 shows signal names (V1H ... V3H) and terminal numbers (35 ... 29). The application DAQami shows channels AI0 to AIO7 (for example).

I cannot find a table which will tell me where to connect wires to pick up channel AIO. 

Link to comment
Share on other sites

  • 0

In DAQami, the first four channels are the voltage inputs V0...V3 and the next four are T0...T3. DAQami AI0 is V0H, V0L, and AIO4 is T0H, T0L.

Use InstaCal first to configure the temperature channels, such as thermistor, RTD, thermocouple, etc. Thermocouples are straightforward to connect; however, the other sensor types require special wiring. InstaCal has a Show Connections button that will display a wiring diagram to make it easy. 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...