Enclosure, noise protection for mcc134s help

[mchm]

Good day,

I am doing a senior design project and looking to enclose my Raspberry Pi 4 with 8 hats stacked on top. Something similar to the picture below. Is there any suggestion as to what to buy or what to create to enclose it, leaving the pins open for connecting and disconnecting flawlessly with minimal effort? Thank you! Any help will be appreciated.

Measurements I am trying to aim for are about 7 x 5 x 10 

 

[DAQman]

We don't have anything off-the-shelf. We'll leave it up to you to find something that works for you. One thing to keep in mind when stacking daqhats, only the top board's screw terminals are accessible. Because of this, you'll need to make connections before mounting the next board. You could add your connectors to the box and wire them internally if you need access to the I/O.