Is USB-QUAD08 supported by ULx for NI LabVIEW in MCC DAQ Software package

[FBo]

Hello,

I am using two USB-QUAD08 devices in one application.

 

One of them is used under control of myown software in C# .NET, in order to drive an X/Y/Z axis scanner with incremental encoders, and it works perfectly.

The second unit is intend to be use by my customer in order to get the encoders position copy in their own software, which generates imaging from a sensor during the scanning.

 

They plan tu develop their software under NI LabView, so my question :

Does the MCCDAQ ULx for Labview supports the USB-QUAD08 device ?

 

I've tried to install it on my computer from the mccdaq.exe installer, but the checkbox for this feature remains gray and unselectable.

Is it due to the fact NI Labview is not installed on my computer, or is it a feature which doesn't supports the USB-QUAD08 device ?

 

Thank you in advance for your answer.

[Fausto]

Hello @FBo.

The MCC USB-QUAD08 is supported by ULx for NI LabVIEW.  LabVIEW needs to be installed in the target system before installing ULx for NI LabVIEW.  Currently, ULx for NI LabVIEW is compatible with 32/64-bit NI LabVIEW 2015-2022.

Regards,

Fausto

[FBo]

4 minutes ago, Fausto said:

Hello @FBo.

The MCC USB-QUAD08 is supported by ULx for NI LabVIEW.  LabVIEW needs to be installed in the target system before installing ULx for NI LabVIEW.  Currently, ULx for NI LabVIEW is compatible with 32/64-bit NI LabVIEW 2015-2022.

Regards,

Fausto

 

Thank you Fausto, 🙂

 

This is what I guess, but I needed to be sure before replying to my customer.

 

Regards.