Dear Digilent Discovery and Accessory Designers no question but a note:
In my application I designed a PCB to reduce patching the D³s cables to one time at setup.
This works fine, however (in contradiction to the probes of my MSO-Oscilloscopes where the digital probes are less or max. 2,54mm) the pins of the D³s adapter cables do NOT fit standard 2,54mm pin headers.
It would be advantageous if Digilent could sell these cables (the solution with the color map is perfect) in dimensions with no over tolerances of the pin’s footprint leading to that problem. In the meanwhile, I will subdivide the pin headers and rearrange with voids between for my upcoming PCB designs.
Question
DigilentFan
Dear Digilent Discovery and Accessory Designers no question but a note:
In my application I designed a PCB to reduce patching the D³s cables to one time at setup.
This works fine, however (in contradiction to the probes of my MSO-Oscilloscopes where the digital probes are less or max. 2,54mm) the pins of the D³s adapter cables do NOT fit standard 2,54mm pin headers.
It would be advantageous if Digilent could sell these cables (the solution with the color map is perfect) in dimensions with no over tolerances of the pin’s footprint leading to that problem. In the meanwhile, I will subdivide the pin headers and rearrange with voids between for my upcoming PCB designs.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now