My AD2 signal generator is abnormal, the output waveform is wrong, and the output as a voltage source is also too small. It should be a fault somewhere. Through comparison and measurement, I found that the voltage of the device is abnormal, but it cannot be repaired without the circuit diagram. Do you have the circuit diagram of AD2, or maybe there is something wrong with this board?
As shown in the figure, the voltage of the device in the frame column part is abnormal, and there are other devices that I have not measured yet.Or can you tell me where the board might be going wrong?
Question
Leo_W
Hi,digilent
My AD2 signal generator is abnormal, the output waveform is wrong, and the output as a voltage source is also too small. It should be a fault somewhere. Through comparison and measurement, I found that the voltage of the device is abnormal, but it cannot be repaired without the circuit diagram. Do you have the circuit diagram of AD2, or maybe there is something wrong with this board?
As shown in the figure, the voltage of the device in the frame column part is abnormal, and there are other devices that I have not measured yet.Or can you tell me where the board might be going wrong?
Thanks!
Edited by Leo_WLink to comment
Share on other sites
4 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now