Waveforms SDK setting AIO voltage range
Hi, I was using the latest Waveforms SDK and was getting a lot of noise that I narrowed down to range setting.
I'll run this:
FDwfAnalogInChannelRangeSet(hdwf, 0, 5);
FDwfAnalogInChannelRangeSet(hdwf, 1, 5);
FDwfAnalogInChannelAttenuationSet(hdwf, 0, 0.01);
FDwfAnalogInChannelAttenuationSet(hdwf, 1, 0.01);
And system reports Chan0 range as 0.60590172535 and Chan1 range as 0.60395088311
But in WaveForms GUI, I can set it by hand where it
Thanks I think I got it setup (my program measurements are the same as the WaveForms GUI running the same test).
Another question: Is there a way to setup the Analog channels to record the data after a trigger on a one-shot acquisition. On the digitial side, I use FDwfDigitalInTriggerPositionSet(hdwf, cSamples) is there an equivalent on the analog side (hence I can time-sync/event-sync the analog and digital). I think it's the analog scenario of this, but I don't want to use the ent