I am having an issue with running the Master Polled example on I2C with the zynq. I have a base design that is set up and runs the self test and repeated start examples and completes them. My issue is that I hooked up an I2C sensor, added pullup resistors, and it is failing. The only thing I have changed in SDK is that I have found the address of my I2C sensor, 0x57, and put it in place of 0x55. I can place my block design and what not here for referencing.
Update - I have assigned I2C pins to W19 and W20 to SCL and SDA respectively.
Question
rcjhy8
Hello All,
I am having an issue with running the Master Polled example on I2C with the zynq. I have a base design that is set up and runs the self test and repeated start examples and completes them. My issue is that I hooked up an I2C sensor, added pullup resistors, and it is failing. The only thing I have changed in SDK is that I have found the address of my I2C sensor, 0x57, and put it in place of 0x55. I can place my block design and what not here for referencing.
Update - I have assigned I2C pins to W19 and W20 to SCL and SDA respectively.
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.