On my FPGA board I have FPGA XC3S400-PQG208 and PROM XCF02S. I am using Digilent’s Adept to program my device by using HS1 cable. If I program only FPGA XC3S400-PQG208 by using HS1 then it program successfully and executes also. While if I choose to program XCF02S by using HS1 it shows massage “Programming Successfully” but it fails to execute. While by using Xilinx ISE 10.1 Impact to programs FPGA XC3S400-PQG208 and PROM XCF02S, it programs successfully and executes also, in this I used parallel cable to program.
I have tried .svf and .mcs both types of files.
All connections are same in both programming methods i.e using ISE 10.1 Impact and Digilent’s Adept.
Question
anshumantech
Hello,
On my FPGA board I have FPGA XC3S400-PQG208 and PROM XCF02S. I am using Digilent’s Adept to program my device by using HS1 cable. If I program only FPGA XC3S400-PQG208 by using HS1 then it program successfully and executes also. While if I choose to program XCF02S by using HS1 it shows massage “Programming Successfully” but it fails to execute. While by using Xilinx ISE 10.1 Impact to programs FPGA XC3S400-PQG208 and PROM XCF02S, it programs successfully and executes also, in this I used parallel cable to program.
I have tried .svf and .mcs both types of files.
All connections are same in both programming methods i.e using ISE 10.1 Impact and Digilent’s Adept.
Attaching screenshot of same please check.
Thank you.
Link to comment
Share on other sites
19 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.