Search the Community

Showing results for tags 'z7-10'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Test and Measurement
    • Measurement Computing (MCC)
    • Add-on Boards
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions
    • Archived

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. I'm trying to get the Pmod Color module for the Zynq z7-10 to work but it doesn't appear to be on. I was following along the instructions from these sites: https://reference.digilentinc.com/learn/programmable-logic/tutorials/pmod-ips/start https://projects.digilentinc.com/arthur-brown/displaying-color-readings-with-the-pmod-color-and-python-ebd794 and I have it connect to the device as such on the board's JA port: Following along with the first link, I skipped the steps where a clock and interrupt were added as the data sheet shows that the Pmod Color IP does not require these. I have included my schematic below. I see that the module has an LED pin (LD1) but it doesn't appear to be on when connected to my powered device. In the SDK, I added a debug 'else' statement to the main() portion of the code to see if the Pmod is receiving data. After running the code on the board, the else statement is the only statement being executed. What could be the issue that my module is not turning on? I took a voltmeter reading, and the Vcc and GND pins are getting 3.3V. Following the instructions of the first link, I noticed they never included a constraints file. Could this be the issue? zynq_ps_main_c.c
  2. Hello Digilent I have a project working with the Zybo Z7-10 board for an embedded PLNX application. First step was to re-create the baseline project (hello world) to get the tool chains in place. We worked with the project and BSP noted below to start with something that works. However there were issues as PLNX didnt come up clean so this is a sanity check first to confirm the starting point. So my question is this the correct project and BSP to get the hello world demo going? If not please provide a link to a complete project for the hello world demo. I used Vivado 2017.4 with the Zybo Z7-10-base-linux and the Zybo Z7-10 Petalinux BSP Project . Zybo Z7-10 Petalinux BSP Project is located here: https://github.com/Digilent/Petalinux-Zybo-Z7-10/blob/master/README.md?_ga=2.87762640.934179241.1585861310-629904370.1584640889 which points to this Vivado project: https://github.com/Digilent/Zybo-Z7-10-base-linux.