Search the Community
Showing results for tags 'video streaming'.
Hello, I have been trying for a while to run this PCAM example that is provided by Digilent on a Zybo z7-10 board: https://github.com/Digilent/Zybo-Z7-20-pcam-5c/releases After spending significant amount of time looking for solutions, I have managed to fit the design on to the board (the initial example is for a zybo z7-20) by turning off the Debug module on the MIPI CSI-2 receiver module. I have successfully exported the hardware and managed to run the provided C++ code. Even though I am able to communicate with the camera module via UART, I can not seem to acquire any video output from it. All I get is a static noise pattern, despite of trying to pick different options from the C++ menus. I am able to see the resolution change and read out the camera's registers (which seem to be correctly set according to the libraries), but that's it. What could I possibly be doing incorrectly? I see the same pattern on a different monitor and have previously tested the hdmi output from the board both through plain VHDL and the IP integrator, via the test pattern generator. I do not see any errors apart from the negative slacks in Vivado, which is a known issue..
Hi, I am following the ZedBoard FMC Pcam Adapter One to Four Camera Demo (https://reference.digilentinc.com/learn/programmable-logic/tutorials/zedboard-fmc-pcam-adapter-demo/start) and I am able to stream the video of all 4 cameras as of now . Is there a way to save the video that are being streamed or even saving a single frame as image ? I am using Vivado v2019.1 and Xilinx SDK 2019.1 Thank you