Jump to content

Search the Community

Showing results for tags 'reset'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Test and Measurement
    • Measurement Computing (MCC)
    • Add-on Boards
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions
    • Archived

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. I am sporadically encountering the included pop-up message when initializing my USB-3114 device through Python UL framework. This is starting to get quite frustrating as it is breaking the automated flow I have developed for this application. Has anyone else encountered this? The python method I am calling to initialize the USb-3114 device is config_first_detected_device()
  2. rob2018t

    Arty Z7 and Reset

    Hello fellow Digilent Members, I hope everyone is well. My Skill Level: I'm slowly progressing my knowledge of FPGA and Vivado using the Digilent Arty Z7-20 and Arty S7-50. Essentially quite a beginner and I've created simple RTL designs to flash LEDs, utilised the Microblaze, Zynq and made a AXI-4 IP block. All really exciting stuff IMO...I just need to make something more useful now. My Question: when designing with the Arty S7-50 I'm able to specify the board and then drag across the reset into my top diagram and/or utilise that when auto completing the design. However in the Arty Z7-20 design there is nothing listed like this in the board peripherals tab (is shows the switches, buttons, LEDs etc). Indeed there is nothing in the XDC constraints file either. I do see that my board is a Rev. B and that the board.xml is only for rev A.0 - I cannot find anything newer. Could someone please advise how to add the reset into my design please for the Arty Z7-20 ? I'm on different computers for the Vivado and my email access so sharing of screenshots or listings will be a little slow (not impossible though if it helps someone determine any issues). many thanks for any consideration :-)
×
×
  • Create New...