Search the Community
Showing results for tags 'hdmi tx'.
Found 2 results
-
I'm following along with the instruction provided on the GitHub (https://github.com/Digilent/Zybo-Z7-10-HDMI/blob/master/README.md) to test the functionality of the Zybo board's HDMI ports. I followed the instruction to the T but cannot seem to get a signal to pass through. At first, I connected my cable box to the HDMI Rx and then I switched to my laptop. In both instances, not only did my TV monitor not detect a signal, but the output on the sdk terminal was that the HDMI-in was unplugged (see first attached photo). The HDP / LD9 LED near the HDMI port turns on, telling me it is detecting a signal. Using the Zybo-Z7 reference manual, I deduced that it might be due to an issue with resolution, but if I try to change the resolution, I get 'stuck' in that menu (see second attached photo) and have to restart the processes by clicking run-as -> Launch on Hardware. I also notice the clock frequency is set to 0, but I'm not exactly sure what could be the issue. I have also attached the block design and xdc file as I'm assuming the issue could be there since the pixel clock isn't running. design_1.pdf Zybo-Z7-Master.xdc
-
Hi, I have requirement of FPGA board with Two hdmi tx and one hdmi rx. Arty Z7 have one HDMI Tx and Rx. Is there any HDMI Tx Pmod available for Arty Z7. Or any board with two HDMi tx? Thanks
