Search the Community

Showing results for tags 'frequency'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Test and Measurement
    • Measurement Computing (MCC)
    • Add-on Boards
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions
    • Archived

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. Hi, I just read the documentation of Xilinx XFFT IP V9.1, read some of the forums threads and also did some testing, but still had some questions especially as far as the IFFT Mode of the IP is concerned. Perhaps somebody did similar experience and can refer to some of them. 1) Is it correct that IFFT mode of IP adds an intrinsic scaling of 1/N to its input which can't be prevented and which is independent from the configuration of the IP and the eventually configured scaling schedule on axi_stream_config bus ? With relation to previous question, is it correct that if i do a scaled FFT (scaling schedule or auto scaling) and put the result vector into IFFT i can't get back original amplitude of time signal because [scaled FFT + intrinsic scaled IFFT] resulting in kinda double scaling ? So with relation to previous question, if approach would be to get back to original time signal after FFT + IFFT an unscaled FFT had to be chosen ? 2) If i choosed the option "natural order" for FFT output and then put the output vector back into IFFT again (after switching from FFT mode to IFFT mode on axi_stream_config bus), do i have to reorder the indices of the vector first to get original time signal back, or can i leave the order as it is (if configuration of IP remains unchanged except switching it to IFFT) ? 3) Is it normal that IFFT doubles the frequency of original signal in its output vector (so that if original FFT input was 1 Period of time signel, you will receive 2 Periods in IFFT output) or is this a mistake in my test application ? 4) Does the "scaling schedule" on the axi_stream_config bus (if the IP is configured for manual scaling) have to be sent only once before starting to read in a frame, or does it have to be sent repeatedly for each sample during the data read in process? 5) Is it necessary to reset the core via the optional "aresetn" port before or after sending a new configuration via the axi_stream_config bus ? Ty and Greetings
  2. I am using the Waveforms software as an oscilloscope and I can see the sample rate, but I need to know how fast it's triggering. I am trying to compare the trigger rate at different trigger levels, which is a number I can get on my normal oscilloscope but I don't know how to get on this software. My only thought was setting up a custom measurement, but I'm not sure what exactly that would look like or if that would work. Thanks for any help!