Search the Community

Showing results for tags 'display'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Test and Measurement
    • Measurement Computing (MCC)
    • Add-on Boards
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions
    • Archived

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 4 results

  1. I am trying to connect my PMOD MTDS to the Zybo Z7, without Arduino. I have integrated the IP files, connected it via block diagram, and set up a FAT32 microSD with the 2 files that are needed also. When trying to connect to Vivado I can seem to figure out how to get to the console for which I can do MTDS Firmware code so I can do a custom UI. Documentation does not help much with connecting this PMOD. Please advise if you're familiar thanks.
  2. Hi, I have a basys mx3 with a pic32MX370 I want to know how to write non-ascii caracters on the LCD. I want to make a Tetris game, but the LCD screen is only 2x16, so how to write very little caracters on the LCD, like one dot at the time. I guess I need to write at the accurate adress on the LCD, but how ? It could be done in assembly or C, I don't mind. I want to do something like the picture: Thank you.
  3. Hello, (FPGA board is Nexys A7 100T) So my end goal is to implement RC4 stream cipher and implement it onto FPGA. I was trying to configure a switch that will utilize the 7-segment 8- digital display and display my original plain text. And another switch that will display the encrypted text. I have attached the sources and test benches below that works. And have screen captured the simulation to show the results. Thanks for spending the time, I'll be high alert for response and try to respond on follow up questions. Can someone help me with this?
  4. MoGamaal

    Display Variables

    I want to know how to display variables on PmodOLEDRGB from Sensors via artix-7 kit in vhdl