Ab25

Hi, not able to run may analog discovery with LabVIEW (2018). From this post I understand that it has not been tested for any versions after 2016 so should I downgrade to previous LabVIEW versions to get it working?

I tried using the Discovery BNC aswell, there are some amplifications happening with the probe. technically when we have BNC-BNC connection it is matched right so at 1x probe it should both show the same values right?

my scope was at 1x and my wavegen was at 1x I changed my scope to 10x & now when I give 2Vpp @ 10KHz I'm reading 2.32Vpp in my scope. Also, by +ve and -ve, I was referring to the signal and ground of the probe.

Hi, I just started using analog discovery 2 - Ni edition. I have noticed some discrepancies but I'm not sure what is wrong, i hope you all can help me. I have generated a sine wave with 10KHz frequency and 10Vpp and I measured it using my analog discovery 2 the connections are as follows : Func gen +ve -> 1+ (analog discovery 2) Func gen -ve -> GND (analog discovery 2) for the op I should be getting a sine wave with f= 10KHz and 10Vpp but I'm only getting 2Vpp. Where am I going wrong? next, I generated 10KHz sine wave using W1 with Amplitude 2V but the DSO measures 456mVpp & the frequency is measured correctly. I'm attaching all the screenshots below for your references, thank you.