Gary L

Hi, Is there an instrument driver for the Keysight EDUX10002A o-scope available? The EDUX10002A has a USB port to interface to a Host PC.

HI, I have a USB-1608G which does not have analog outputs. I need to create a single digital output pulse of 3-5 seconds I would copy and modify this solution for a 2nd digital output pulse for another duration of 1 or 2 seconds.

Hi Fausto, The example you provided is for the USB-1608GX-2A0, I have the USB-1608G. I had to modify the example you sent. The AOUT0 and AOUT1 terminals (analog outputs 0 & 1) use the MCC-DRV - Analog Output module in DASYLab. These pins are not supported in the USB-1608G version. "Two analog output connections (AOUT0, AOUT1) – USB-1608GX-2AO only" See USB-1608G-Series.pdf pg. 12 For my modified example, I wired the TMR screw terminal to CTR0 (input) and DIO0 and used the meter and chart as in your example. I used a Digital Input in SE mode. Not sure what sampling rate to use. I get this block error now: To summarize, If I understand correctly the TMR pin is enabled using the Counter Output Module.

HI, I'd like to enlarge the module in my Workspace. They are small for me to see, read text in the boxes, and connect the wires.

HI, I want to use the USB-1608G TMR output pin 53 for some loopback testing of analog and digital inputs. I may want to also use the pins 46/48 for A0/1 clock-out. MCC-DRV does not show the TMR module. MCC-DRV does not show a module for the clock-out pins, are they programable? The USB-1608G does not have counter outputs, only counter inputs. Any suggestions? Are these pins supported? See pic below.

Hi, Installed Sound Card Driver for Dasylab Trial Version instead of the driver for the MCC USB-1608G. When trying to change it in the Configurator, I get an error message: Please install Universal Library, then install package. See png attached. How do I do that? I still have 28 days left for the trial.