jakubdr

Hi @attila, thank you for the detailed explanation. From the above, can I assume that the control signal of the power supply (probably OPA197 input - as seen in the EEVblog 1596 video) will contain a clean signal up to 200kHz? And one more question: Eclypse Z7 is now supported by WaveForms. Do you plan to support this development kit by WaveForms in the future? Regards, Jakub

Hello @attila, thank you for the quick response. I was just wondering if the CH2(V+) output is modulated by, for example, some amplifier that can handle higher frequencies (kHz, as shown by the dropdown control). But it was just a question. I understand it's the power source and not the AWG. I have to decide between AD3 and this one. The two wave generators are tempting, as is the memory buffer. Jakub

Hi all, I'm thinking of buying ADP2230 and trying the software functions of waveforms SW (in DEMO mode for now). I was interested in the possibility of generating a frequency greater than 2.5Hz in the CH2 channel (v+). The datasheet gives the value of 2.5Hz as the maximum. Is it really possible to use higher frequencies on this power supply channel? Channel CH3 (v-) is limited in dropdown selection to 2.5Hz. Regards Jakub