[Genesys ZU-3EG Mounting Dimensions]

Thank you for the quick response.  

I noticed on the mechanical drawing some of the mounting holes are identified w/ "0" markings and others w/ "B".  I was unable to locate a table that indicates the hole size, can you provide the drill hole size for the two markings on the drawing?

[Genesys ZU-3EG Mounting Dimensions]

The mechanical_genesys_zu.pdf shows the center placement of the mounting holes on the ZU-3EG but does not appear to indicate the hole size (diameter).  I am looking at mounting two of the boards to a single tray via standoffs and would like the know the size standoffs required.  It looks like eight (8) primary mounting holes in two (2) different sizes (shown in the attachment).  It appears the red mounting holes are one size and the blue are another smaller size.

[Genesys ZU-3EG ECC DRAM]

We are looking to purchase the Genesys ZU-3EG evaluation boards for developing our firmware/software.  If I am reading correctly, the board is wired to support ECC memory in 64-bit access (72-bits w/ the ECC).  However, the board is shipped w/ non ECC capable DDR4 DRAM?  Can someone recommend an ECC DRAM that is in stock and compatible w/ the Genesys ZU-3EG development board?  Is it possible to have the boards shipped w/ ECC capable DRAM at time of purchase?

Thanks