BenjaminW

My problem was solved with the help of MCC Support Germany! I got the tip to access the E-1608 IP address using a DHCP router. I configured the DHCP router to use that net the E-1608 was in before the firmware update failed. After connecting the E-1608 and my PC to the DHCP router my E-1608 was detected by InstaCal automatically as E-1608-BOOT. The Firmware-Update worked afterwards as you described. My E-1608 is alive again and works normally with firmware version 1.03. Thank you for your help!

Thank you for your instructions, JRys. Unfortunately it didn't work. I cannot establish an ENET connection from InstaCal to the E-1608 device. InstCal don't detect the device. Also ping is without response. What IP address is used by the bootloader by default?

Hello, I tried to perform a firmware update on a MCC E-1608 device but unfortunately it failed. The device is not more reachable now. There was the firmware version 1.01 installed and I tried to update to 1.03. For performing the firmware update I used InstaCal Version 6.73. During the update process InstaCal showed the message similarly “Device could not be detected in boot loader mode”. After that I waited about 15 minutes without any progress. So I closed InstaCal and repowered E-1608. Since that E-1608 powers up only with both LEDs (power and activity) permanently blinking synchronously. The E-1608 is permanently not more reachable, neither via InstaCal nor via Windows ping command. Also resetting default network settings by pressing Factory reset button during powering on is without any impact. What could I do to make my E-1608 working again? Is there a possibility to flash the E-1608.hex file using a Pickit 3 programming tool?