Jump to content

Russ2010

Members
 View Profile  See their activity

  • Posts

    9

  • Joined

  • Last visited

Russ2010's Achievements

Newbie

Newbie (1/4)

1

Reputation

  1. Russ2010 started following Do not see any ulxx icons , New ULx for NI LabVIEW , How to control Solenoid valves with TC-32 in labVIEW and 1 other
  2. Russ2010
    I downloaded the new software but it does not install on the test machine due to saying it needs LabVIEW 2015 or higher installed. It has the 2023 Q3 runtime engine and NI MAX installed with all the drivers for my code to work. I do get my program to work but I am unable to change the Thermocouple's for the TC-32 device. At least i am up and running but I would still need to be able to change the TC's type. Or is there a new way as well?
  3. Russ2010
    I will be trying the labview runtime and instacal on the test PC next week when I get back to that project.
  4.    Fausto reacted to an answer to a question: TC-32 network connection
  5. Russ2010
    This is adding to what is above. Running into the same issue. I do think I have the alarms turned off but still can to seem to get. I can run the labview code with no errors popping up. When I measure with a DMM the output is active is 0VDC and when I turn it off it still remains 0VDC. I did set up Do0 through DO7 the same way. per the attached picture. Do i have the setting right? for labview to control the outputs?
  6. Russ2010
    the problem was with my PC and network setting. I added a 4 port nic card to the system. when i switch the tc-32 network to the onboard it work fine with Instacal and InstaCal needs to be close to have labview work and call the device. so I reset all network port in windows 10 and the system works great.
  7. Russ2010
    Gotten the TC-32 working on the usb connection no issues. for my test setup i would need to use the TCIP connection for the overall system. I can get InstaCal to see the network device with no issues. but when i try to setup the channels for the program and select browse option on the labview screen comes blank. Any help or what am I doing wrong?
  8. Russ2010
    When I create an executable with the TC-32 would i need to install instaCal on the test PC too?
  9. Russ2010
    Nice example but how do you tell the device what type of thermocouple it is?
  10. Russ2010
    Thanks Looking through the examples i can not find an example for the TC-32 that is using the network connection. by chance you have one?
  11. Russ2010
    I installed the MCCdaq with LabVIEW 32 and 64bit when I run the program I do not se any ulxx or even any new icon added to my profile. I am running LabVIEW 2021.
×
×
  • Create New...