Jump to content

ZGSWA

Members
  • Posts

    4
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

ZGSWA's Achievements

Newbie

Newbie (1/4)

0

Reputation

  1. Hi JRys, thanks for your reply and suggestion, I directly use TDMS Write vi write the data into tdms file,and finaly the tdmsfile is correct with my expectation. thanks alot, ZGSWA
  2. Hi, I use ulx for labview creat a daq program(The channel selected as picture,and the data of DAQ_B was saved as TDMS file,the rate is 1000). As normaly, I will get 8 channels data in TDMS file,but now I get 77 groups totaly 77*8= 616 channels file.And every channel of the data just get a small part of the data(and when I set number of samples perchannel is ‘-1’ in ulx Read vi also same, ). The signal source is Instacal. And I run same Labview program on two computers get different data(At my own PC the data is normal,the other is same as I mentioned before.The version of LABVIEW and Ulx F Labview. instacal is same in the two PC ).The program and the version of instacal is attached. The version of Labview is Labview 2021,32Bits. Is anything wrong between ULX for Labview and Instacal?If so which version can I Use ? Or is there something wrong with my program? If so,please point out it. Best Regards and thanks a lot,😀 ZGSWA
  3. Hi, I need to use labview to program two USB1608gx. At the same time, two USB1608GX are needed to collect data together.Is it feasible to do so?   But there are no relevant examples in the MCC Knowledgebase.   Is there any important point I need focus on? How could I do it on labview? Thanks alot.
×
×
  • Create New...