dooeun

Thank you for your response, I will give it a try.

According to the Arty A7 Reference Manual Reference Manual at this link: https://digilent.com/reference/programmable-logic/arty-a7/reference-manual?srsltid=AfmBOoq4Oe6IZ0qUJd_4UWE4LZf6co78rt69EvzhIGw6YHhODPt4ej2u, I understand that around 2MB of the flash memory is used for booting, leaving approximately 14MB available for user data. However, I have not been able to figure out how to access and utilize this space. Could you provide an example or project that explains how to store data in this available memory, such as starting from which address and how to proceed? Thank you in advance. +If it is difficult to provide an example with this specific product, I would also appreciate it if you could provide an example using the Basys 3 board.

It is said that the LED of 'LD13' lights up when the micro 5pin is connected to the fpga and pc and switched on. But my led doesn't glow. How can I solve this? +When connecting the device, the connection tone sounds several times, but the connection is not actually connected and is disconnected.