Jump to content

huangluyang

Members
  • Posts

    2
  • Joined

  • Last visited

huangluyang's Achievements

Newbie

Newbie (1/4)

0

Reputation

  1. Dear zygot, thanks so much for your reply, yes I2C protocol/functionality isn't an issue, we've already verified that IP in previous designs. I'm just not sure whether does Digilent Artix boards hardware support the I2C requirement or not, according to your description, it sounds like that it only support maximum 400KHz data rate right? But we want to run I2C protocol at 1MHz (Fast mode plus), does it support that speed? Thanks in advance.
  2. Hi there, I wanted to use Artix®-7 35T FPGA Arty Evaluation Kit for prototyping of our ASIC, which has an I2C interface. Our ASIC is I2C slave, and our host is I2C master. Host will communicate with our ASIC through I2C bus for register programming. My Question is that does the evaluation kit support to bring out SCL/SDA signal from FPGA to any of the socket/pin on the board? So we can connect the 2 signal to same I2C bus with out host. If it supported, will it to be done through the PMOD connector? Thanks in advance😁
×
×
  • Create New...