@DerekM I have already installe d the driver from cypress and you can see in the photo that the UART configuration are correct!! the problem still there?
@DerekM I built a very simple project just the zynq processor with the "Hello world program and still can't see any thing on the terminal. Then I used just the pre-build zed platform provided in SDK with the "Hello world program and still the same problem.
I'm trying to use a VDMA tutorial. I have a ZED Board and I'm using VIVADO 2019.1
Every time I run the SDK, it shows nothing on the terminal. After that I tried to boot from the SD card and it also shows nothing.
PS: I checked that I'm using the right terminal